Router Bits
Router Bits
3 Wing Slotting Cutters
3 Wing Slotting Cutters
Straightforward and easy to use, these Slotting Cutters make small slots into your workpiece for a wide variety of applications. Compared to 2-Wing cutters 3-Wing cutters are designed for a better cut finish.
Upcut Spiral Router Bits
Upcut Spiral Router Bits
Upcut bits are the go to choice where having a clean bottom surface or getting maximum chip evacuation is most important. The up cut action of the bit pulls the chips up and out of the cut allowing for maximum chip evacuation. Because the chips are being pulled up this will result in a clean bottom edge of the cut
Panel Pilot Plunge Router Bits
Panel Pilot Plunge Router Bits
Panel bits were created to be used with a pilot guide to assist when cutting out holes in thin panels.
Point Cutting Roundover Router Bit
Point Cutting Roundover Router Bit
For lettering, engraving, signmaking, fluting and decorative trimming. Note: Due to very fine plunge point, bit is not guaranteed against breakage.
Upcut Spiral Ball Nose Router Bits
Upcut Spiral Ball Nose Router Bits
Designed for carving and modeling operations. Their improved tip geometry gives a superior cut.
Trim Blades
Trim Blades
Designed to trim and groove both hard and soft plastics. These blades run in conjunction with the blade arbors. Blades are reversible for right or left hand rotation cutting.