Router Bits
Router Bits
3 Wing Slotting Cutters
3 Wing Slotting Cutters
Straightforward and easy to use, these Slotting Cutters make small slots into your workpiece for a wide variety of applications. Compared to 2-Wing cutters 3-Wing cutters are designed for a better cut finish.
Upcut Spiral Plunge Router Bits
Upcut Spiral Plunge Router Bits
Spiral-flute bits combine a shearing action in cutting with an augering action in chip clearance. The shearing action yields an especially clean accurate cut while the augering action clears chips from the cut. The ‘Up-Cut’ shears from the bottom up pulling chips from the bottom up thus allowing deeper penetration with less stress on the tool. An excellent choice for mortising.
Straight Flute Plunge Router Bits
Straight Flute Plunge Router Bits
Straight Flute Plunge Router Bits offer a lot of versatility by allowing you to start a cut in the middle of a work piece.
Straight Flute Overhang Flush Trim Router Bits
Straight Flute Overhang Flush Trim Router Bits
Unlike a standard Flush Trim bit, these bits allow a small overhang.
Panel Pilot Plunge Router Bits
Panel Pilot Plunge Router Bits
Panel bits were created to be used with a pilot guide to assist when cutting out holes in thin panels.
Upcut Spiral Ball Nose Router Bits
Upcut Spiral Ball Nose Router Bits
Designed for carving and modeling operations. Their improved tip geometry gives a superior cut.
Trim Blades
Trim Blades
Designed to trim and groove both hard and soft plastics. These blades run in conjunction with the blade arbors. Blades are reversible for right or left hand rotation cutting.